what is difference Auto-transformer and ICT ?

1 Answers   CG, Descon,

---

What is AVR in Turbo generator in Thermal power plant?

5 Answers   Thermax,

---

hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz

0 Answers  

---

Energy metering: On the property I am renting, the supply voltage is 2 x 110 volts. These 2 x phases enter a energy meter which then exit the meter to over head lines to my house. Question 1. The meter is single phase 240 volts but is being used as 2 x phase(2 x 110volt), is this acceptable? if not, please give me the reasons. The meter details are as follows: 60Hz 15amp Imax 100 amp Kd 3,6 Wh/R 1 fase 3 hilos Model FX 231. I think it was manufactured in Brasil From this meter, the cables run along over head aluminum conductors,I estimate the cross sectional area to be 25mm diameter, but the neutral is only about 10mm square diameter, which cover a distance of 170 meters and then terminate with an underground cable of 65 meter length, total length = 235 meters. There must be a huge voltage drop over this length. This line is protected with 2 x 200 amp aluminum fuses after the meter, there is no main switch in the distribution board. These 2 phases connect directly onto 2 busbars. Surely the neutral should be the same size as the conductors if not more? Question2. What are your thoughts about this installation, should there be better protection, is the neutral too small? During the night, the lights dim then brighten all the time, this cannot be good for my electrical appliances. In my home, I only have a small electric geyser and fridge, my stove works off gas. But when i use other appliances like the washing machine or microwave oven, the light dim. The internal wiring of this house is done with solid hard drawn copper wires and of course, they have to be under rated. I am a retired electrician by trade, but not on the metering and over head mains side, my experience is on the factory maintenance side of things. Your expertise on these matters will be greatly appreciated. Please inform me how to rectify or make any improvements Kind regards, my power bill is very expensive, so I need to know how to bring it lower. Kind regards, Brian

1 Answers  

---

diffrence between alternating and pulsating field?

1 Answers  

---

---

AMF (auto mains failure) control for DG sets at home.

1 Answers  

---

What happens if there is no nuetral in the power system?

5 Answers  

---

how are reversing the direction of dc motor

0 Answers  

---

WHAT IS MVA RATING OF KOTHAGUDAM THERMAL STATION POWER TRANSFORMER?

2 Answers   CESC, Power Grid,

---

what is reactive poower

3 Answers  

---

Send me Model Question paper for the post Scientific Assistant in NPCIL

0 Answers  

---

for star delta connection,,why the contactor star not burn,when red,yellow and blue cable is looping.

2 Answers   Mahindra Water Utilities,

---