Answer / satyendra bhai patel

dear friend,


just check orifice data sheet where u will find out the min
and max dp within lp & hp legs of tx.

as per given data set lrv and urv of tx from HART.

as per LRV & URV set 4-20 ma out put of tx.

thanks.


for any help contact me on 9005091827

Answer / a.sreenivasa rao

Dear friend Pl specify the Flow Transmitter type, i.e. Mag
flow, vortex flow, DP flow,Mass flow etc.....

Answer / satya

if it is a dp type then how we calibrate ,suppose
the boiler is of 60 TPH , then URV value , LRV value and
its unit just mention , also cal calculation

I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.

0 Answers  

---

Sir, my yokugava FF TYPE LEVEL transmitter us bad, i don't have spares available, i want to replace it with a Rosemount FF transmitter, please tell me what procedure to be followed and what changes to be done in dcs part.

1 Answers   BPCL Bharat Petroleum, OEG,

---

wHAT IS BURST MODE IN TRANSMITTER?

1 Answers   Bhel,

---

A temperature sensor (RTD) connected via a temperature transmitter is adjusted to give an output of 4ma at 60 deg and 20 ma at 600 deg. This output (4-20ma) from the transmitter is connected to an IGBT-inverter to control a high speed (-12,000 to +12,000 RPM) DC motor. And in the inverter it is programmed as, for 4ma the motor speed will be -3,000 RPM and for 20ma the motor speed will be +10,000 RPM. The question is : If the motor speed is +5,500 (RPM), what will be the temperature? (-sign indicates that the motion is in reverse direction).

9 Answers  

---

how far the two wire transmission (loop power) maximum distance suitable?

2 Answers   PCIL,

---

any questions on motor and energy conversions machines?

0 Answers   ABB,

---

What is the minmum distance between the electrical panel and Instrument panel

1 Answers   Dodsal,

---

please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com

0 Answers  

---

INtools Trainining

1 Answers   Monarch Techno Engineering Solutions,

---

How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?

0 Answers  

---

how to design orifice plate?what is the equation?

0 Answers   REL,

---

What is i/e or o/p transmitter(ma/v)?

1 Answers   Emco,

---