Answer / blackchicagogent

Smart instruments are those that can be communicated with "HART" (Highway Addressable Remote Transmitter). The device stores all data related to calibrating it.

Answer / www.islamqa.com

It's a micro-processor based instrument & do all the above.

Best of luck

Ahmed Sabry
Instrumentation & Control Engineer
Mob: +2 0122 1367310

Answer / khalid

Smart instruments are those that can be communicated with "HART" (Highway Addressable Remote Transmitter). The device stores all data related to calibrating it. 

Answer / irfan

Self-Monitoring, Analysis, and Reporting Technology

Answer / prakhar jain

smart instruments are those take lesser input & give greater
output.

what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .

0 Answers  

what is the deluge ? How can its working?

2 Answers   KOC,

Question on maha cement

0 Answers  

What is the reason for not giving very High Proportional Gain Kp in PID Controller?

2 Answers   ABB,

pl give the guidance for DUBAL written test

1 Answers  

How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?

0 Answers  

I have flow transmiter DP range is 0 to 5000mmwc,(convert) Display to be show in m3/Hr.

3 Answers   Orient,

when an eddy current probe is installed inside of a turbine or compressor in case of probe problem same as:crash of head of probe,changing the scale factor because of low measuring gap(physical gap is ok(example=1.14mm)but voltage is reduced(example=-6 volts),is any way to check the probe,when the ohm of probe is ok.thank you,(Karim Tavakoli)

1 Answers  

in differential pressure transmitter,min&max pressure range for hp&lp

0 Answers  

if differential pressure created by orifice falls below vapour pressure of liquid flowing through it what will happen

1 Answers   BARC,

how to design orifice plate?what is the equation?

0 Answers   REL,

What are the advantages and benefits of using PLCs to automate a section of a plant?

2 Answers