there are two candidates p and q in an election.During the
campaign,40% of the voters promised to vote for P ,and rest
for Q.however, on the day of election 15% of the voter went
back on their promise to vote for P and instead voted for Q.
25% of the voters went back on their promise to vote for Q
and instead voted for P.suppose,P lost by two votes,then
what was the total no. of voters.
Answer / lomesh vadhankar
These are the kind of questions which makes us confuse
because of the use of percentage of percentage.
For simplicity, we can take 100% people as x number of people.
So, now as we have assumed, we have total x number of voters.
Now, according to question,
Total voters for P = 40% of x = 0.4x
Total voters for Q = 60% of x = 0.6x
Now, on the day of voting:
P lost 15 % of his voters and got 25% of Q's votes.
So, Votes for P = 0.4x - 0.15*0.4x + 0.25*0.6x
similarly, votes for Q = 0.6x - 0.25*0.6x + 0.15*0.4x
Now, P lost by 2 votes.
So, Votes of Q - votes of P = 2
Putting these values of P and Q's votes, we have
(0.6x - 0.25*0.6x + 0.15*0.4x) - (0.4x - 0.15*0.4x +
0.25*0.6x) = 2
This gives x as 100.
Thus total voters are 100.
For making this question more simple, take an assumption as
100% people = 100 people. It will make everything easy.. :)
Is This Answer Correct ? | 5 Yes | 0 No |
can we copy the software from a transmitter using hht(hart 275) ?
if we have 450 mm heigth boiler drum level ,so what is span & zero value for a dpt tranmitter
which gas or which liquid is filled in capillary of dial type temperature indicators on power transformers
defination of radial vibration?
where do you give the 4-20 ma i/p in a MIL control valve?
If the average power during generation is zero, why do the analog meters have + and - ?
what is the difference between dcs & plc
How is PH sensor works ?
Explain about 4 wire instrument concept & tell about its wiring fron sensor in Field to PLC panel.Explain with an example?
how to do loop checking pls email to shanavaska2000@yahoo.com
why we use by pas on a positioner? When can a by pass be not used on a positioner ?
IS THEIR ANY AGEING EFFECT ON FLOW NOZZLE, ORIFICE, MANIFOLD, OR TRANSMITTER ?