Answer / mizpah

Working stress method of design based on the elastic theory in which materials, concrete and steel are assumed to be stressed well below their elastic limit under the design loads. Working stressess (permissible stress) for the materials are determined by dividing the ultimate or yield stressess by suitable factor of safety values.

Limit state method of design based on limit state concept, te structure shall be designed to withstand safely all loads liable to act on it throughout its life;It shall also satisfy the serviceability requirements, such as limitations on deflection and cracking. The acceptable limit for the safety and serviceability requirements before failure occurs is called a "limit state". The aim of design is to achieve acceptable probabilities that the structure will not become unfit for the use for which is intended, that is that it will not reach a limit state...

What glue is least sticky?

0 Answers  

---

how many no of light weight solid blocks of size 600x200x200mm required for 1cum of block work

4 Answers  

---

A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.

0 Answers  

---

dialation means

0 Answers   APGenco,

---

How much Pressure will apply in Water proofing Grouting method to fill the crack in beams or slabs?

2 Answers   GMC,

---

For 1 cu m of concrete required 1.54 Cu m times dry volume. Pl give clarification of 1.54 factor

1 Answers   RASA, Unity Infraprojects,

---

A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals

0 Answers  

---

How long does it take concrete to harden?

0 Answers  

---

What is a BBS?Find out the cutting length for a foundation size 600 x 600, cover 50 mm?

3 Answers   CSL Group,

---

Which word is coolest among the 26 alphabets?

8 Answers  

---

What is Refuse Area ? And What is Definition ?  

2 Answers  

---

in brick masonry,what are the types of bonds?where which type of bond is used?& why?Also what is header & closer?

1 Answers  

---