Answer / sagar upadhyay

If the load is purely reactive, then there is no need to find
out real power since it will be zero. But if there is some
resistance in the circuit, real power tells us the loss in
the resistor.
Reactive power is used to measure the power factor of the
circuit. since, higher the pf, higher will be the power
quality of the circuit. We always try to reduce the reacive
power keeping apparent power constant & in this way pf is
improved.

Why mostly conductor made by 7 nos wire?

2 Answers  

---

What is the use of Exciter in generator? & what will be the current of Exciter in 500 KVA DG Set?

2 Answers  

---

what is the difference between PLC and embedded system

3 Answers  

---

hw to find transformer is in normal position? whether its in charged condition or not? except humming sound?

9 Answers   ABB,

---

why we use lamination or layer by layer cor used?

4 Answers  

---

single phase voltage 230 and Three phase voltage 450 why 690 voltage

1 Answers   XYZ,

---

Why use the vcb at high transmission system ? Why can’t use acb?

0 Answers  

---

wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?

0 Answers   FLS,

---

What difference between TRANSFORMERS and TRANSDUCERS???

1 Answers  

---

What is difference between insulating medium and fault current interruption medium in a switching device.

0 Answers  

---

Cb closed condition if there is a tcs fail whether cb will trip or not

0 Answers   AADC,

---

What is the diff. between single compression and double compression gland

0 Answers   ASL,

---