if the load is reactive then what is the use of calculating
the real power and what is the use of reactive power
if my question is wrong please excuse me..
- 1 Answers
- 2991 Views
- I also Faced
- E-Mail Answers
Answer Posted / sagar upadhyay
If the load is purely reactive, then there is no need to find
out real power since it will be zero. But if there is some
resistance in the circuit, real power tells us the loss in
the resistor.
Reactive power is used to measure the power factor of the
circuit. since, higher the pf, higher will be the power
quality of the circuit. We always try to reduce the reacive
power keeping apparent power constant & in this way pf is
improved.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.
What’s electric traction?
surge tank, hrc fuse, earthing transformer, firm power objective type
Is it true online ups having bypass mode if it is true then why we called ups because it is interrupting power when goes in bypass mode
WHAT IS counter flux IN CT?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
STATE WORKING OF VACCUM CIRCUIT BRAKER?
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
What are the types of windings according to the construction?
What if high voltage side circuit breaker of a ehv transformer instead of lvcb? Kindly elaborate.
While testing a ZCT what parameters have to check or measure?
What is maximum power transfer theorem?
