is the power of a single phase induction motor(Fans) is
constant under varying speeds?
Answers were Sorted based on User's Feedback
Answer / anoop
The power is not constant.In this case it will varies with speed
Is This Answer Correct ? | 4 Yes | 1 No |
Answer / brijesh soni
it's depend on control of speed,
if you control speed with electrical regulater so power wii
never cheng,
if you control speed with electronic regulater so power wii
be cheng as speed,
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / kamal yadav
power will be change.as the resistance change then the voltage will be same but current will be diffrent so thats we can say thats the currents will be change then power also change.
Is This Answer Correct ? | 0 Yes | 0 No |
what size of copper busbar use for 11kv 630A
what is stacking factor?
What is meant by derating factor?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
how can we select the type of wire.what factors we have to look on it , do we have some formula to calculate it. please guide me on it
what's the use of cvt and wave trap in 400kv switch yard.......
what must be the mf for a meter with the following conditions. line ct ratio-100/1 line pt ratio- 220kv/110v meter pt ratio- 3X63.5V meter CT ratio- -/1 A
how desiel generate sart fail of eb?
What is the rating of your substation and what are the different types of substations?
why the LED of my electrical meter glows even after the line has gone. what actually the reason?