why we maintain turbine rpm always more than what we need
to run generator in thermal power plant
Answers were Sorted based on User's Feedback
Answer / salai jeyaveeran
in thermal power plant we use to maintain the same rpm what
the generator need because we have a tolerance in frequency
of 50Hz so no were we use to maintain the higher RPM in
turbine if it so there will be a speed reducer gear through
which the turbine shaft is conected to generator shaft
Is This Answer Correct ? | 7 Yes | 0 No |
Answer / vignesh.raja63
basically the turbine connect with generator and initially
high torque will produce so the turbine rpm more than
generator and it give constant power
Is This Answer Correct ? | 4 Yes | 0 No |
welding defects
what is pulverisation
Enumerate the parts of Main Switchboard
What is the cause of backfire in boiler
what is the difference between 1st angle and 3rd angle projection?
What are the different theories of failure under static load, explain ?
sir, please send me the last three years exam papers conducted by BHEL- RECRUITMENT EXAM FOR SUPERVISOR TRAINEE FOR MECHANICAL ENGINEERING. A Soon as possible. i would be greatfull to u
What is blading efficiency of steam turbines ?
Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?
I need BHEL Engineer Trainee written test papers in Mechanical stream.
Why tampering to be done?
why not maintain 7.0 ph in boiler ,when 7.0 is not acidic & not basic so why maintain 9+ ph?