Interested to Buy Any Domain ? << Click Here >> for more details...
why we maintain turbine rpm always more than what we need
to run generator in thermal power plant
- 2 Answers
- 5367 Views
- I also Faced
- E-Mail Answers
Answer Posted / salai jeyaveeran
in thermal power plant we use to maintain the same rpm what
the generator need because we have a tolerance in frequency
of 50Hz so no were we use to maintain the higher RPM in
turbine if it so there will be a speed reducer gear through
which the turbine shaft is conected to generator shaft
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Which element causes difference in higher and lower heating values of fuel ?
sir i have to face an interview for marine trainee engineer on 15 sept tell me some related questions which r genrally asked...
hallo I am looking for technical theortical knowledeg in air flow inside pipe and tunel's such as resisten of surefa's calculation and sempal's of calculation hopethat some budy can halp my thank you from devas
what is procedure of measuring operating length of mechanical seal . (in case of centrifugal pump)
What is meant by shell and tube heat exchanger?
DIFFERENCE BETWEEN CODES,STANDARDS & SPECIFIFCATIONS?
What is the thermal efficiency of a diesel engine?
If gas turbine is operating on part load, how droop will affect the output with respect to frequency.
PLESE SEND ME OLD TECHNICAL N APPTITUDE QUESTION PAPERS
In 1983 what changed about the length of the meter?
Define earth lamp?
Why and what cause of leak fuel oil in high pressure pipe of main engine?
what is pulverisation
can any1 provide me the PLACEMENT PAPERS FOR BHEL
Hoew to represent unilateral tolerance, as Bilateral tolerance in engg drawing...? Example: 1.295 +0.000 and -0.10, as unitolerance, write the value in bilateral tolerance?
