Answer / bala

Consider
200 VA / System
60kva x 0.8 = 48 kva ( Efficiency =0.8 )
Calculation
= 48000/200 =240 workstation or system

Answer / muthuramn

u can connect upt o 240 system

Answer / i h rao

Computers are working on DC power supply. If the DC conversion if suitable for 60 cycles then there will be no problem. Normally, DC power supply units are designed for both 50 and 60 cycles. Cycles depend on the RPM of the Alternator. Less the RPM less the cycles.

Terminal blocks is used for segregate the connections... There is any principle for terminal block..?

0 Answers  

---

what is blocking diode and what is the use of it in tne control circuit.Pls Explain it.

1 Answers  

---

HOW TO CALCULATE GROUND FAULT CURRENT IN 430V 4000AMP AIR CIRCUIT BREAKER?

2 Answers  

---

What is the SPEED of electricity?

1 Answers  

---

what is stator inter turn fault?

1 Answers  

---

why are installed water leakage detection system data centers & server rooms

0 Answers   Reliance,

---

which type of motor is suitable for water pump?

1 Answers   IIM,

---

Hi.I want to ask how to calculate contactor rating current? for example I have 460 V , 100 A (induction motor) calculate contactor rating current?

2 Answers  

---

how to set the transformer differential relay

1 Answers   Divis Laboratories,

---

Iin ESP why positive is grounded ? why not negative ?

0 Answers  

---

how a synchronous motor is used as a resistor,capacitor and an inductor?

3 Answers   Technocon Services,

---

Three phase power is measured with two wattmeeter for balance three phase load.the reading of one wattmeter is zero.we can conclude that the power factor of balance load is?

1 Answers  

---