Answer / k.prakashchandra

Both the answers are correct except for calculation error in
No. 1.You have to consider IR drop also. Upto 25 m length 4
A/ sq mm and upto 100 m 2.5 A/ sq mm may be taken as
carrying capacities.

Answer / shantanu mishra

100 Amps. You can take current density as 4 amps per square
mm for copper. For Aluminium cable it can be taken 2 Amps
per square mm. This also depends upon many other factors
such as whether cable is under ground, or burried or
whether it is overhead. tou shouls also takeinto account
ageing factor also.

Answer / shantanu mishra

I will just make a little correction..." you should also
take into account the derating factor.

Answer / sandip

please refer the manufacturer catlog for
this que. but u have to ask that how to
calculate the current carried out in
25sqmm cable ? actully i also dont know
abt the calculation. if any one have
theformula please send iton my mail add.
sandippatel2310@gmail.com

Answer / satveer sagar

1 sq mm will be taken 3 times current

Answer / sri

10 amps because 1sqmm =2.5a

how we identify between current transformer and potential transformer without having it name plate?

5 Answers   L&T, TATA,

What is the difference between ACB & MCCB?

7 Answers  

as ac supply is given 2 the transformer why it doesnot depends upon powerfactor????

2 Answers  

what is power factor? is it good or bad for a system? what will happen if power factor increase or decrease?

4 Answers   Bhel,

What is bushing?

4 Answers  

how to make an earthing certificate

0 Answers  

1.wat is the purpose (or)function of regulator? 2.wat is the purpose of stabiliser?

3 Answers  

I am having a DG set.The 415 V from Generator is step up to 460 v and then the same is used for Induction furnace. before Step up, I am connecting LT load to my factory use. When Induction furnace is in service from DG, when i try to start a motor, the generator is tripped.Please tell me the reason.

3 Answers  

how to identyfy cable sizes?

4 Answers   IAF, Mylan,

while doing the excitation current test on power transformer what is the value of voltage to be applied? Nomonal rated voltage or 10% of rated voltage? Is it necessary to apply on high voltage side?

1 Answers   ACC,

what is the design factor that affects the size of a motor ?

3 Answers   Reliance, SGI,

If single phase supply is 220v. then why three phase supply is 660?

2 Answers