Answer / natha

if dc is applied,the nature is non sinusoidal so no flux linkage.this leaves us with simple v= i*r type situation(referring to basic equations).in transformers the winding resistance is low.if 220v dc is applied and resistance of winding is 0.5 then current i=220/.5 which is high value shorting the winding and eventually burning it out.
but why the hell apply dc to transformers in first place

Answer / k.prakashchandra

Tr is an ac machine.If dc is applied ,the current will be
equal to voltage divided by dc resistance as inductance and
back emf are absent.There will not any output in the secondary.

Answer / k.prakashchandra

Tr is an ac machine.If dc is applied ,the current will be
equal to voltage divided by dc resistance as inductance and
back emf are absent.There will not any output in the secondary.

Answer / surender kumar

It will burn out.

what r the preventive maintenance of air compressor

1 Answers   Jindal,

---

What happen when change order of CT in GIS feeder?

0 Answers  

---

What is turbocharger in a generator?

2 Answers  

---

What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.

0 Answers  

---

How the soft starter control the starting current in three phase squirrel cage AC Motor?

1 Answers  

---

Megger type of instrument is used to check??

8 Answers  

---

How Negative Phase Sequence Relay works in case of Synchronous Motor?

4 Answers   L&T,

---

What is the ratio of true power to apparent power in an ac circuit?

0 Answers  

---

What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.

0 Answers   APTransco,

---

how to select the isolation tranformer for siemens 802dsl cnotroller

0 Answers   Siemens,

---

Is it legal of using 3 phase motors in 2 phase in Tamilnadu?

2 Answers  

---

Mention how NPN and PNP transistor works?

0 Answers  

---