What will happen if apply dc source for power transformer
- 4 Answers
- 5056 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Tr is an ac machine.If dc is applied ,the current will be
equal to voltage divided by dc resistance as inductance and
back emf are absent.There will not any output in the secondary.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
Sir, I have applied for the of Assistant.engineer of NPDCL. please send me all AP TRANSCO AND JENCO solved papers of previous exams . I requested send me the papers to my id as soon as possible (rajanikanth_peddi@yahoo.co.in) (This is very urgent) Thank You,
which type of stability limit is higher,steady state or transient? why?
what are symmetrical and non symmetrical components in electrical installation.
Make a list observation on Transformer?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
Why we use ups battery and dsdb battery in thermal power plant
what reason of line current and phase current in star connection and line current and phase current not equal in delta connection?
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
How 48-relay (incomplete sequence) functions?
what is meant by surge? what we called for high currents?
What is mathematical model of a control system?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
I am apply the AAI. So i want electrical sample question paper in technical with answer my id is vijayjobsmart@gmail.com
