how to solve temperature error in compressor?
Answer / u.prabhagaran
first cross checking,after change the element.
Is This Answer Correct ? | 4 Yes | 0 No |
the square root type transmitter r used to which applications
I work on a electronic positioner transmitter 4211 at the field.I connect my multimeter in series to get the current output then I calibrate it to 4ma in 0% of position of the valve and 20ma in 100% position of the valve.My problem is in the field I get the correct output current based on my multimeter but in the dcs they only receive 40% in a output 20ma of this positioner.Then I try to simulate in this analog card and they receive the equivalent percent on the value that I simulated.Is ther any possibility to reset the zero and span of this positioner 4211 fisher.And what other possibility I can do to fixed this.This is my email add ( landicho_randy@yahoo.com )
Full form of KKS when use DCS.
How many interlocks at turbine? Plz explain briefly
0 Answers MRPL Mangalore Refinery and Petrochemicals Limited,
Example of dry contacts & wet contacts?
SIR MAY I KNOW IF RADAR TYPE LEVEL TRANSMITTER SHOWING IN THE FIELD 0 % LEVEL AND IN DCS SHOWING 100% THEN WHAT IS THE CAUSE I CLEAN THE CHAMBER & TAKEN ONLINE BUT ONLY ONCE ITS BECOME ZERO IN DCS BUT AGAIN 100% SHOWING IN DCS,THEN I REMOVE THE POWER SUPLLY AND CONNECT IT AGAIN .IS IT OK BUT STILL IN THE DCS ITS 100% AND ON THE DISPLAY ITS INITILAZIATION PLEASE HELP ME READRING THIS?
Why grounding is necessary? Give example with diagram.
0 Answers Bright Point, DS Group,
What is a PID?
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
Can we use PLC in Hazardous Area?
Is it possible to convert 4 wire transmitter to convert to 2 wire with additional relay.Please send detial with drawing,i will appreciate.
in which mode of the zener diode act when load voltage is approximately constant