Answer / mojinkoshy

The HT/EHT/MV voltages are mentioned as the multipliers of form factor ie. (3.14/2 root 2) = 1.1

Answer / k.prakashchandra

I had given answer to this long back.In the question
voltages are not correctly mentioned as V and KV.The first
electrical appliance was 100 V DC bulb.When AC system was
introduced ,the same bulb was used for 110 V AC applying the
form factor to make it equivalent.Then 11/33/ etc KV
systems came into being just have simple voltage ratio for
transformers.However we have 400 KV instead of 440 KV.

Answer / k.prakashchandra

220 is the root cause for others

what is rating providing of contactor,relay,fuse unit for motor output power

2 Answers  

---

what is the accaptable voltage between neutral to earth & How to reduse the resistance of earth in chemical earthing

4 Answers  

---

HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory

0 Answers  

---

what is the difference between direct loading and indirect loading?

1 Answers  

---

what is the relation b/w KW and KWH? plz explain with example.

6 Answers   FAG,

---

Explain in brief description about the operation of DG sets.

0 Answers   Siemens,

---

in 6.6 kv vaccum circuit breaker vaccum bottole vaccum capacity ????

0 Answers   Divis Laboratories,

---

What is tan delta point of transformer?

2 Answers  

---

In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?

0 Answers  

---

Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?

0 Answers  

---

In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?

0 Answers  

---

A circuit breaker on detecting fault will a. Open b. Close c. Open and trigger the alarm

2 Answers  

---