why generator is design for lagging P.F(power factor)?
Answers were Sorted based on User's Feedback
Answer / abhi
the genrator is design for lagging p.f. because normally
genrator run on normal p.f.,but sometimesthe force of input
is very high.so in this way the generator does not
working.so we design generator for lag p.f.
Is This Answer Correct ? | 1 Yes | 2 No |
Answer / shekhar saxena
IF generator is designed for leading power factor then, the
leading current will harms the windings of generator and
ultimately the there will be damage of whole machine.
Is This Answer Correct ? | 2 Yes | 6 No |
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
What will be the minimum megger value of 1700 KVA Transformer? a) Do megger value varies according to climate conditions and area . b) If megger value is 100 mega ohm is it good for new transfomer. Explain?
What is the difference b/w RMU & substation
what is rated current and operating current?
why commutator are not used in rectification purpose in power electronics?
what is dielectric heating
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
How two nos. 130 kw D.C motor get synchronise using D.C drive.
How can we increase the capacity of Energy.?
what is interpose vt where it is used and y it is used?
Explain and give examples about VCB?
0 Answers AZ Engineering, Vodafone,
why the value of impedence is taken as %impedence in fault currrent calculation