why generator is design for lagging P.F(power factor)?
- 3 Answers
- 6189 Views
- BSES, I also Faced
- E-Mail Answers
Answer Posted / abhi
the genrator is design for lagging p.f. because normally
genrator run on normal p.f.,but sometimesthe force of input
is very high.so in this way the generator does not
working.so we design generator for lag p.f.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
what is the importance of earthing system on the generators big capacity and small?
design a 3 bit synchronous and asynchronous counter using T- flipflop
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
Is it possible to measure the voltage of a battery from a single terminal?
WRITEDOWN FEW RELY CODES
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
What was your role in the silicon evaluation/product ramp? What tools did you use?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
send me any model test paper of clerical post of state bank of india.......
how does WTI work ?
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
