Answer / nitin

It should be less than 5 ohm

if an alternator or turbine using fuel to produce ele energy and we didn't connect load to the ends then where was gone the ele energy

2 Answers  

---

Why is tan-delta test and capacitor measurement done on alternator?

0 Answers   TD Power Systems,

---

previous year paper of ntpc bhel for degree in electrical enng

0 Answers  

---

Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above

0 Answers  

---

What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.

1 Answers  

---

what is the difference between high impedance and low impedance circuit?

2 Answers  

---

how to modify DOL control panel into Delta Y connection?

0 Answers   ABB, PDCS,

---

can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?

0 Answers   NovaTech,

---

what is the formula for backup time of online ups?

1 Answers  

---

What is corkscrew rule?

0 Answers  

---

Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com

0 Answers  

---

we have one pumping station and 4.6 MW 7 no.s synchronous motors.so there is no required HT capacitor to improve power factor.But we have two no.s of 25 Mva power transformer connect to distribute the power for motors connect with 220 kv line.So i have required the HT capacitor to improve power factor at HT side i mean power transformer bus side.So please suggest how much HT capacitor banks required for same.

1 Answers  

---