Why distribution transformer secondary voltage is 0.433kV
instead of 0.415kV.all other switchgear rating are 415
volt??
Answers were Sorted based on User's Feedback
Answer / eric foo
Why need dc supply for operating electrical ht switchgear?
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / k.prakashchandra
Voltage rating does not matter up to 650 V.433V transformers
are used whenever distribution lines are long ,to maintain
minimum reqd voltage at tail end .
Is This Answer Correct ? | 1 Yes | 2 No |
The distance between distribution transformer and switch
gear is slightly more,in that distance voltage drop is
occured
Some times in switch gear we need a single phase supply,
if it is 433 volt means, the phase voltage is 250 volt,in
case of 415 volt ,the phase voltage is 239 volt.
Is This Answer Correct ? | 1 Yes | 3 No |
Why the size of transformer decreases if we increases the frequency?
5 Answers Graphics Engineering,
what is the principle of operation of domestic fan?? what is the role of capacitor in it??
how to select electrical equipment such as fuse,dg,transformer,motor,msb,wire,cable as per the connecting load..please mention any books to design,take licence
0 Answers Gujarat Electricity Board,
In star and delta connected systems , for driving power and as well as light load which one you will preferred?
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
what is the minning of propotional, integral, derivative ?
what is the effect of leading power factor
3 Answers Aurobindo, R L Steels and Energy,
power formula
what is phase to phase fault? what is line to line fault?
2 Answers Phoenix Technologies,
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
which circuit takes max. load & which circuit takes min. load i.e. SERIES CIRCUIT OR PARALLEL CIRCUIT??
what is resver in electrical enginnering with answer