wht is dcs architecture ? can u give example?
Answers were Sorted based on User's Feedback
Answer / satya
DCS ARCH:- it means total dcs system , it includes
engineering station , operating station , dcs panel like
analog panel(AO&AI) , digital panel (DO & DI), system
cabinet , pdb cabinet , and all DI, DO, AI , AO from
field terminals , also from mcc , from drive panel . this is
whole dcs arch
Is This Answer Correct ? | 14 Yes | 2 No |
Answer / mithilesh kumar
DCS ARCHITECHTURE IS RELATED WITH "FIELD CONTROL STATION"
(FCS) AND HUMAN INTERFACE SYSTEM(HIS).
FIELD SIGNAL FOR EG.(DI,DO,AI,AO) IS CONNECTED WITH FCS
PANEL AND IN FCS USED NEST,VLNET,VNET, DEPEND UPON TYPES ON
DCS.
HIS IS CONNECTED WITH EHERNET.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / charles
DCS architecture is a Engg. drawing where engg and operator (HMI) stations, history modules,printers and the DCS components (consists of CPU,communication,memory, power supply modules) are connected by LAN/LCN/UCN redundant communication cables to form the complete system.
Other third party devices like
plc,gateways,SWAS,CEMS,comunication protocol converts etc are also connected by communication cables as per the customer requirements
Is This Answer Correct ? | 0 Yes | 0 No |
Please any one can explain how to calibrate transmitter (smart) online with out remove from the container suppose it is interface level or static pressure level measurement we dont want to remove transmitter from the container mean it is running plant please give me detail. thankx brothers
What is the use of keyphasor in turbine.
7 Answers Hindustan Zinc, R&D,
can any send me a forbes marshall dtron 316 manual
what are the problem's will accure in dcs or plc hadware and what are the solution for it?
It is desired to reduce effect of 50Hz pick up in a thermocouple measurement. If a third order LP filter is used for this, what should be its cut off frequency, if gain should be 0.001 at 50Hz.
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
how many type conductivity sensor ?
Why we are using thrust bearing at turbine side?
how to install Differential pressure transmitter in gas line.i need transmitter down side.
what is the daily job of an instrument commissioning supervisor
What is the function of positioner in control valves? does the control valve operate without positioner?
how to draw a flowchart for swapping two numbers using bit wise operators?