Answer Posted / charles
DCS architecture is a Engg. drawing where engg and operator (HMI) stations, history modules,printers and the DCS components (consists of CPU,communication,memory, power supply modules) are connected by LAN/LCN/UCN redundant communication cables to form the complete system.
Other third party devices like
plc,gateways,SWAS,CEMS,comunication protocol converts etc are also connected by communication cables as per the customer requirements
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why we take %i0.0 as input for twido plc
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
why fuse block is not used for AI signal?
full process of gas turbin?
What is difference between ESD and PLC please Explain me clearly.
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
Why are the uses 24vdc in industries
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
how to turbine speed measurement?
how to calibrate steam control valve in steam turbine
Decibel.
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
