Answer / k.prakashchandra

It is a piece of curved and bent MS sheet inserted between
the eye of the stay rod and the stay wire to prevent
abrasion (rubbing) between them. It is also called 'bow piece'

Answer / k.prakashchandra

Sorry ,the above reply is for thimble.Bow piece is
triangular iron rod used between stay wire and cross arm and
stay rod.

what is meaning of bus riser

0 Answers   TeamLease,

---

What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?

0 Answers  

---

after parallaing two generators current is shooting up in both the generators.for ex: load is 400 kw..after paralling and load sharing current in running gen is approx 900 amps and incoming is 750 amps which is too high when trying toshift the load current in incoming gen is coming more than 1300 amps and both getting tripped and making blackout..

3 Answers  

---

How to design the earth grid for lightning protection in an industry

2 Answers  

---

how does calculate loss correction factor in transformer

1 Answers  

---

---

i want to syncronise 5 nos of DG. How? pls reply

3 Answers  

---

How calculate cable size & voltage drop for the following requirement connected load 150 KW distance cable length 1000 M voltage 3 phase 415 v.

1 Answers  

---

How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.

0 Answers  

---

In a synchronous motor. if start is running at high speed.  What will be the starting torque : Higher Lower Zero

0 Answers  

---

how does a tube light choke working?

2 Answers  

---

How to calculate the Efficiency of Chiller

0 Answers   Knight Frank, L&T,

---

if our load in 3 phase circuit is 4000 amp. calculate the capacity of capacitor panel if line power factor is.80 .

1 Answers   ST Micro,

---