Which type of gear train used in Wrist watch?

Categories >> Engineering >> Mechanical Engineering
Suggest New Category

Question Posted / ramalingeswarao_88

6 Answers
25889 Views
Bhel, Escorts, L&T, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Which type of gear train used in Wrist watch?..

Answer / tarun

epicyclic gear

Is This Answer Correct ?

80 Yes

15 No

Which type of gear train used in Wrist watch?..

Answer / santhosh kumar .k

riverted gear train

Is This Answer Correct ?

30 Yes

11 No

Which type of gear train used in Wrist watch?..

Answer / c.gopinath

Epicyclic gear train used in wrist watch.

Is This Answer Correct ?

15 Yes

8 No

Which type of gear train used in Wrist watch?..

Answer / dipesh g desai

Epicyclic Gear Train

Is This Answer Correct ?

5 Yes

7 No

Which type of gear train used in Wrist watch?..

Answer / kunda chundal

Loda gear

Is This Answer Correct ?

1 Yes

3 No

Which type of gear train used in Wrist watch?..

Answer / guest

HELICAL GEAR

Is This Answer Correct ?

4 Yes

32 No

Post New Answer

More Mechanical Engineering Interview Questions

How much is 1 kn in kg?

0 Answers

what is the thermodynamics?

8 Answers

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers

what is the highest critical temprature of refrigerant?

2 Answers Hitachi,

What are the loads considered when designing the Nut and Bolts?

12 Answers

What are the effects of carbon on the properties of steel?

0 Answers

please any one send the fenner model question........

0 Answers

what is BOOSTER pump which is used in power plant?

4 Answers

Hello friends, can any one give path to get BEL mechanical sample papers .