In synchronous generators field is rotor and armature is
stator.Can we take the output at the rotor in case of
synchronous generator by the dc excitation on the stator?
Answers were Sorted based on User's Feedback
Answer / sdvyas
Yes,electricity can be generater in either case.
However,due to high voltage 6.6 KV/11 KV it is much more
safe to kept HV on stator. Further, if we take HV on the
rotor, rotor will have more mass as the total curent will
be carried out by HV windings only. It will also give more
thrust on the bearings.
Therefore, it is safe and reliable to have field windings
on the rotor part of the generator. Brushless exciter is
the best choice for any syncrogenerator.
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / nithi
yes, we can.There two types of synchronous generator
1,rotor as a field 2,stator as a field.
so,what u have asked is come under the 2'nd category.
but,generally second one is not adopted in practical due
to various technical issues.
Is This Answer Correct ? | 3 Yes | 3 No |
why the carbon brushes are used heat created rotating parts in eiectricity
I would like to install the largest KW alternator to a 200 amp aluminum bus box in my home. Is it possible to install a 250 KW 400v 251amp synchronous alternator to my home?
carbon zinc cell voltage?
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
What is the function of trip neutral close switch?
i want to estabilish an loss energy storage system,such that it can store electricity lost during the transmission of electricity in conductor,so that this system stores energy lost during transmission and supply it to street lights during night
what is corona ?
how can we change the rotating direction of single phase AC induction motors?
12 Answers Heubach Colour, L&T, MNM Jain Engineering College,
What is on line ups and off line ups?
sir i want previous entrance exam papers for written test
why overcurrent fault occurs in power system.
if transmission voltage expressed as the multipple of form factor(1.11)........11,33,66,220 etc......then why madakkathara substation(kerala) voltage is 400kv..not 440.....?