why we increase the small speed of turbine when alternator
just synchronized to grid in steam power plant

Answers were Sorted based on User's Feedback



why we increase the small speed of turbine when alternator just synchronized to grid in steam power..

Answer / ayush

consider grid as a load for time beiing nw if while a
sudden load is applied on alternator there will b large
drop in speed momentrily due to its synchronous behaviour
torque angle will increase to increase the devloped torque
to cope wth load torque suppose there was no little speed
increament in that case large load causes large hunting so
to avoid large oscilaation that r difficult to damp small
increase in speed of turbine is done so built required load
torque wthout loss of synchronism due to hunting even
though there will b oscillation but due to increase in
turbine speed r much less so can b easily damped by damper
windings.

Is This Answer Correct ?    5 Yes 2 No

why we increase the small speed of turbine when alternator just synchronized to grid in steam power..

Answer / subu ravichandran

this s a simple concept.compare this with a person climbing a bus during running condition. he have to run bit faster than the bus to climb it.here s the same scenario.

the increased speed of turbine is to avoid hunting of machine when it is suddenly subjected to load

Is This Answer Correct ?    1 Yes 1 No

Post New Answer

More Electrical Engineering Interview Questions

110 KW MOTER DOL STATER 240SQ.MM CABLE MOTER AND STARTER DISTANCE IS 110 METER WHAT IS VOTAGE IN MOTER END AND SYSTEM VOTAGE IS 415 V HOW I CAN CALCULTE

2 Answers  


Why the ceiling fan has three blades, why not two,four or five?

4 Answers  


1000kva = how much kvar

3 Answers  


Induction generator has = A negative speed B negative slip C negative voltage D negative current

2 Answers  


Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??

0 Answers  






IF we have 500kva transformer & know the current on HT & LT side, how can we consider for its breaker?

5 Answers  


Why electrical heaters are not provided with overload relays in circuits

1 Answers  


why the impedence of the transformer is expressed in percentage?

3 Answers   DEWA,


what is breaking capacity

1 Answers  


WHATS THE DIFFERENCE IN USING THE 125% AND THE 250% FACTOR OF SAFETY IN CALCULATING CIRCUIT BREAKERS CAPACITY IN MOTOR APPLICATION??

0 Answers  


Impedance relay is directional relay or non directional relay?

2 Answers   KSEB, NTDC,


where is highest transmission voltage is used in india

2 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)