how to use one 4-20mA signal for two indicater or controller
& give necessary precaution.
Answers were Sorted based on User's Feedback
Answer / anand
Use Isolatrer/Mux 1 I/P & 2 output.......
1 230 v source to energise the mux and 2 outputs can be
got...
Is This Answer Correct ? | 7 Yes | 0 No |
Why the Proximitor supply should be Negative voltage? Why should not we give Positive voltage to the Transducer?
why pressure 3-15psi is used as industrial standard and what is the reason
2 Answers JAL International, UltraTech,
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
when we are using HART COMMUNICATOR why we are using 250 ohm resistance while using HART COMMUNICATOR.
HOW TO CALCULATE WAKE FREQUENCY FOR THERMOWELL???WITH OUT SOFTWARE..
How to calibrate H2s Dectector
all questions related to instrument technician in any offshore oil and gas company.
pls send me the 10 years technical question papers of NTPC AND BHEL
15 Answers Bhel, NTPC, ONGC, UCE,
What are the interlocks we have to check during the start up of LP/HP compressor?
What are the reliability data ,like failure rate etc,for bently nevada systems & vibration probes.
full process of gas turbin?
what is the diffirence between Earth and Neutral