What is the Gap Should maintain for HT cables crossing of LT Cable?

What is the Gap Should maintain for HT cables crossing of
LT Cable?

Question Posted / raghunathgwd

2 Answers
7525 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is the Gap Should maintain for HT cables crossing of LT Cable?..

Answer / rajiv

the gap should be bear minimum 300mm from both cable trays
and these are not crossed and if required then the angle
should be of 90 degree.

Is This Answer Correct ?

6 Yes

1 No

What is the Gap Should maintain for HT cables crossing of LT Cable?..

Answer / kirti

if the two cables are bare ones then the di-electric
strength has to be calculated between them. if they are
insulated ones then it can be kept in contact, i.e one over
other.

Is This Answer Correct ?

2 Yes

4 No

Post New Answer

More Electrical Engineering Interview Questions

Define the term factor of inertia.

0 Answers

What is the knee point of voltage of CT?

5 Answers NTPC,

How much current flow in no load condition of a motor?

8 Answers

Why we use two wattmeter during block rotor test and no load test of 3phase induction motor? And how can we understand the neat power requirement of from this test?

2 Answers

What is an isolation transformer?Why do we need isolate circuits?Where do we use them?

2 Answers

what is difference between neutral and ground wire?

2 Answers TCS,

What is Primary and Secondary Injection Test of CT and Relay.

2 Answers

how the transmission voltage ranges are decided like 11kV,33kV,66kV,132kV,220kV,400kV,725kV.... why not choose the transmission line voltage as 23kV,164kV,440kV?? what's the reason??

3 Answers

what is the condition for YnD11

0 Answers Bhel,

What is E.M.F ?

6 Answers

why earth fault current is always less than the o/c

2 Answers

what is CRGO Transformers?

6 Answers MSETCL Maharashtra State Electricity Transmission Co Ltd, TATA,

For more Electrical Engineering Interview Questions Click Here