What are the reliability data ,like failure rate etc,for bently nevada systems & vibration probes.

1 Answers  

---

How does temperature bath work? How does coil gets heated only by applying some current?

0 Answers   Process Control Technologies,

---

What Is Pre- Commissioning Package +what is DCS & ESD Pre- Commissioning for Instruments Please explain your answer on practical ground base

0 Answers  

---

If the Barrier Fails during online then What will be the control valve position in field or Positioner action in the field.

3 Answers  

---

what is the difference between RTU & MTU in SCADA system?

4 Answers   Bosch,

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers   OPaL,

---

what is insdustrial vibration.who it works. give atleast 2 types of insdustrial vibration

0 Answers  

---

what is meant by calibration

3 Answers  

---

i am from instrument branch i want paper patern of mahagenco . any pevious years paper regarding my branch send me please . please.....

0 Answers  

---

which type of signal used in instrument?

3 Answers   Emco, Makson, Sail, TATA,

---

How to Calibrate Radar Level Transmitter in Field

0 Answers  

---

A motor is taking 15 Amps at no load and 60 Amps at full load. and a valve has to open 10% at full load and 80% at no load. How to draw ladder logic.(PLC).

2 Answers  

---