What is flow ,level, pressure transmitter ?and units?
Answers were Sorted based on User's Feedback
Answer / binu
We can use differential Pressure Transmitter for measuring
Flow, Level and Pressure in common. Just need to change
type of measurements. we can choose the units depending
upon the process requirements like mmH2o, mBar etc.
Is This Answer Correct ? | 7 Yes | 4 No |
Answer / nirmalya basu
Basically transmitter transmits data which is sensed by our
sensors at the field in the standard form to any
controller.It would be 4 - 20ma, 3 - 15psig, .2 - 1kg/cm2, 0
- 10vdc.When this kind of transmitter is used transmit
pressure data then it is called pressure transmitter and
flow transmitter for flow, level transmitter for level etc.
Is This Answer Correct ? | 5 Yes | 4 No |
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
i have calibrate rosemount make level transmitter , wht can i do ? my tank capacity is 30,000 liter
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Isometric drawings are generated during _________________ phase of a project
Please asked me How calculate DCS controller memory.
Linear amplifier.
If we increase D what will be the controller action?
In dcs contol valve parameters showing like this Gain=1 or 2 , ti=7 sec, td=20sec. But temp,pressure,level control valves we are using in which type parameter side using ti,td clearly tell me
Draw block diagram BOILER COMBUSTION loop & Explain
1 Answers Bajaj Hindusthan, Exxaro,
What is the SCAN time of a DCS/PLC? What is the typical value for scan time of DCS and PLC?
6 Answers Essar, Gasco, Siemens,
what is the criteria to decide conductor size of a cable ?
Can anyone say that formula of Converting the Diff. Pressure into Flow in Kg/Cm2 or any explaniation of Orifice Plate, Beta Ratio , How to calculate