Answer / g.navaneethan

If transmitter is calibrated for 0 - 200 deg.C then
(120/200)*16 4
9.6 4
= 13.6 ma

WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN

0 Answers  

---

We do have a problem in the company that is one PT connected to PlC which is mean 1 out of 1 in PLC system we do have the PAHH is 55 mbar and PALL 8 mbar with a timer of 15 sec for the PAHH the problem started when PAHH goes more than the set point which is 55 it reached up to 71 but due to timer doesn't trip . We force it and we checked everything nothing there . We replaced the transmitter problem still there the reading goes more than the 55 bar the range for transmitte is 0- 60 mbar . So we did loop check , aculaizing valve , wiring all are okay . What the possible causes for this ???

2 Answers   National Petrochemical Company,

---

what is diff b/w neutron and ground?

3 Answers  

---

Why three wire is using with a RTD?

3 Answers   ABB, MAHINDRA,

---

thru which signal does µP communicate with memory

3 Answers  

---

what is control valve and how is work

5 Answers   Descon,

---

What is difference b/w absolute & gauge pressure? EXPLAIN

2 Answers   IFFCO,

---

T.x range -0.1 to 0.2 milibar,so how much mili ampear at 0.1 milibar?

7 Answers   Sugar Factory,

---

diff bw range and span?

3 Answers  

---

Explain the working principle of lvdt?

0 Answers  

---

this site is owned by an nonsense

0 Answers   Bhel, Prolific,

---

ON RADAR INTERFACE LEVEL TRANSMITTER IF DI-ELECRIC IS WRONG WITH CONTINIUS PROCESS THAN HOW CAN INDENTIFY OR HOW CAN I PUT NEW DI-ELECTRIC VALUE?(ROSEMOUNT-TDR-3300-COXIAL PROBE TYPE)

1 Answers   Chevron Phillips,

---