WHAT IS THE DIFFERENCE BETWEEN A DC MACHINE OUTPUT AND
RECTIFIER OUTPUT...
Answers were Sorted based on User's Feedback
Answer / dpk_1fj
DC Machine output is smooth dc voltage and rectifier output
is a pulsating dc voltage.
Is This Answer Correct ? | 48 Yes | 11 No |
Answer / saurabh bhardwaj
IT DEPENDS UPON THE POLES IN THE D.C. MACHINE IF THERE ARE TWO
POLES IN D.C. MACHINE IT WORKS AS THE FULL WAVE RECTIFIER
IF WE INCREASE NUMBER OF POLES MORE THAN 2 THEN THERE IS A MORE
DC POWER IN COMPARISON TO FULL WAVE RECTIFIER
THE GENERATOR OUTPUT IS MORE SMOOTH THAN RECTIFIER
Is This Answer Correct ? | 10 Yes | 0 No |
if rectifier is half-wave type then there is difference . in case of dc machine the output will same like full-wave rectifier.as we know that inside dc machine emf induced as sinusoidal but due to commutator the output becomes like full-wave rectifier type.
Is This Answer Correct ? | 12 Yes | 3 No |
Why we have short circuit the secondary of the transformer
How to calculat the ratio of HT\LT in energy meter
i want to know is it possible to generate usefull power by coupling generator with motor & supply gives to motor by battery source then generator generates power. remove the battery source given to the motor & feed the supply from some of the generated power supply to the motor & motor runs continously. generator generate power contnously.is it possible ?
what is the difference between RCCB and ELCB?
what is G.O.D.S. ?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
why the conservater tank alwes made upper side of transformer???
What type of protective system we uses in L.V. distribution panels?
what is the difference between 2-phase and 3-phase?
we have one 75kw motor 380 volt 3ph amp134 please advise which size of cable required