wat is the need of capacitor on aceiling fan?
Answers were Sorted based on User's Feedback
Answer / hariprasanna
ceiling fan consists of a single phase induction motor,as it is not self starting..so to start it we use capacitor and run also using the same capacitor...
Is This Answer Correct ? | 12 Yes | 0 No |
Answer / josh
the capacitor is used to give the motor its starting
torque.. without the capacitor the fan wouldnt start
spinning.. although if u gave it a push it would run..
Is This Answer Correct ? | 7 Yes | 4 No |
if there is shaded pole motor are used then there is no
need of the capacitor but when there is permanent capacitor
are used as fan motor then only then capacitor must be used
for high starting torque to rotate the fan as usual
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / b.praveen patnaik
The basic concept beyond using a capacitor in the ceiling
fans is that:
In the ceiling fans we use induction type motors which
requires a starting torque.so in order provide the starting
torque we use these capacitors.
dats it.
Thank u...
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / rushi913@gmail.com
IF their is permanet capaacitor are used for as an fan
motor then it must use the capcitor their is need to
increse the starting torque of the motor to running the fan
as we need.Also to used as fiter in ckt.
Is This Answer Correct ? | 1 Yes | 3 No |
what is the formula for backup time of online ups?
How we select the vector group of 3phase power transformer?
What is difference between earth leakage relay and restricted earth fault relay ?
whats the one main difference between UPS & inverter ? And electrical engineering & electronics engineering ?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
What is chopper
principle of power export and import in captive power plant.Is it depends upon voltage,current or frequency?Plz explain briefly.
What is power factor?
why the measure taken in multiplication factor of 11for voltage like.. 110V,220V,440V,1.1KV,6.6KV,11KV,33KV,66KV,110KV,132KV,220KV
Why are iron cores in transformers made laminated?
whay we transmit power in 3phase no in 4 or 2 or 5......etc?
Why TAP changer provided in primary side of HT transformer ? and why not in secondary?