What are the loading factors to be considered for transformer sizing/selection

What are the loading factors to be considered for
transformer sizing/selection?

Question Posted / shivakumarkinni

3 Answers
6940 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What are the loading factors to be considered for transformer sizing/selection?..

Answer / omar aziz

1. Maximum Demand
2. Downstream equipment starting characteristics
3. Total downstream kVA

Is This Answer Correct ?

4 Yes

0 No

What are the loading factors to be considered for transformer sizing/selection?..

Answer / aaman samal

for the selection of transformer the following points are
necessary

1. power demand
2.power factor
3.load factor and types of load

Is This Answer Correct ?

3 Yes

0 No

What are the loading factors to be considered for transformer sizing/selection?..

Answer / abhishek robinson

Thermal Loading of transformer
Fault Current

Is This Answer Correct ?

2 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

Why does inductive loads consume KVARs?

0 Answers

why cable i burning without tripping. how can protect led street lights

0 Answers Cosma,

if 40 watt bulb has higher resistance then a 100watt bulb then according to joul farmula p=I^2R the 40 watt bulb more power consume then 100 watt bulb.

5 Answers

Why we use the D-curve MCBs in critical power distrubution.

4 Answers Sodexo,

Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient?

0 Answers

what is the difference between surge arrestor and surge supressor

1 Answers

electricity board have asked me what size meter i need fitted in my garage, its a 415volt supply and i want to run six 20amp supplies tolifts and things plus ten florry lights , what kva meter do i need??

2 Answers HCL,

why the capacitor bank unit is kvar

3 Answers Infosys, L&T,

How to model "IF ELSE" statement in matlab simulink?

4 Answers

What is the meaning of loop in transformer

0 Answers AST,

Sir, Please tell me that how I will calculate the efficiency of rectifier. Because input is ac and output is dc. Is it right to put two unlike signal together.

2 Answers

We have 11kV/110V three phase indoor potential transformer in 66/11kV Sub-station, where the failure of PT is frequently happening and the rating of the PT is 0.2 class accuracy, with primary star and seconday (two cores) star connected. Some experts has suggested to not to connect the PT Primary neutral to the ground because when transformer neutal NCT connection is loose; the faulty current will flow through the PT primary neutral, resulting into failure of PT. My question is: Is it necessary to remove the primary neutral connection of the PT from ground? if not, what would be the reason for failure of PT. Please guide me.

2 Answers KPTCL,

For more Electrical Engineering Interview Questions Click Here