Answer / badri narayan satpathy

UPS are generaly two type
1:- on line
2:- off line

1:- on line
In the on line ups at the starting time the ups output
is syncronise with the input supply and when the input
supply is break then the backup supply is starting withen 0
milli second .

2:- off line
in off line ups allways the input power is directly
bypass to output when the input is break then the inverter
section is start to working withen 4 to 6 milli second

Answer / guest

on line ups is one off the

salam,hi, i need to know what the spesification of 300amp msb...

0 Answers  

---

As we know induction squirrel cage motor torque Directly praprortinal to applied voltage in star connection & delta also. If I connect 55KW Motor to DOL starter in load condition does motor withstand the load & what will be the current withdrawn ? motor will not fail ?

0 Answers  

---

what is the difference between contactors & relay.

2 Answers  

---

why there is a humming noise in transformer

6 Answers  

---

I want to ask a question which i faced during testing of Capacitive Voltage Transformer in AIS. We have measured the C1 , C2 individually , but when we start to measure the total C1+C2 , the testing equipment shuts down and says low loading. Kindly is it possible to find the total capacitance by using measuring device. kindly briefly explain the procedure.

0 Answers   AIS,

---

wat is the first thing dat is needed, 2 lay a cable in some area??

0 Answers  

---

What do you mean by PT-100?

8 Answers  

---

CAN ANYBODY EXPLAIN WHAT ACTUALLY MEAN BY THE PHASE DEFFRENCE? R,L,C CIRCUITS?

5 Answers  

---

What are the essential parts of a transformer?

2 Answers   NIT,

---

what is arc flash and what are the hazards involved

0 Answers   Reliance,

---

How we select the cable rating

1 Answers   BTM, Videocon,

---

We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?

0 Answers   Siemens,

---