Answer / murugan

Require: 2 feeder 1 buscoupler
if fault occurs in any one transformer buscoupler sense using synchonise checking relay(same voltage, same freq, same phase checking) automatically closes and transfer the load of faulty feeder to healthy feeder.

Answer / hpl

autochangeover scheme applicable for 2 transformer
feeder/feeder and one buscoupler or 3 incomer 1
buscoupler.when one incomer will down(only under
voltage).buscoupler will come automatically.voltage sensing
relay is required

Answer / phanidra putta

For Auto Changeover Scheme do refer the below link.
https://electengmaterials.wordpress.com/2019/01/17/auto-changeover-scheme/

why permanent magnet generator have higher frequency of 400hz

3 Answers   Jaypee,

---

Why the capacitor bank is keeping on for electricity supply and keeping it off for generator supply

3 Answers  

---

why did the BDV test in transformer?

2 Answers   Jindal Steel and Power,

---

What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?

6 Answers  

---

if a.c supply is given to the motor,, what happen?

0 Answers   Bhel, L&T, MSEB,

---

why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?

0 Answers  

---

i have seen a picture of a power plant. in that pic. i saw chimney like giant structure which were spreading smoke like something...i want to know is it chimney or cooling towers, as my friends use to say.

2 Answers  

---

which tap of the transormer you will use in critical condition(worst)?

1 Answers  

---

what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips

0 Answers   KPCL, MDIM,

---

what is the difference between Earthing,Grounding and neutral?

3 Answers   Biocon, Tata Steel Limited,

---

Why only mesh earthing is used in G.S.S.?

2 Answers  

---

Why we are checking the vector group & turn ratio of Xformer while PM?

1 Answers  

---