How a oxygen sensor & analyzer work at boiler or furnace,
whats the principle & science is beyond this,How O2 sensor
sence & convert signal & move toward analyzer & analyzer
show reading in percent?
Answers were Sorted based on User's Feedback
Answer / k.surya mutyalaro
apart frm electro-galvanic fuel cell, o2 mesrment is also by
zirconia and paramagnetic prnciple,and thus produces mV.
in a analyser ,there b a programming ,which produces the %
accrding to voltage generated due to ionisation
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / arun kr
An electro-galvanic fuel cell is an electrical device, one
form of which is commonly used to measure the concentration
of oxygen gas in scuba diving and medical equipment.
A chemical reaction occurs in the fuel cell when the
potassium hydroxide in the cell comes into contact with
oxygen. This creates an electric current between the lead
anode and the gold-plated cathode through a load
resistance. The current produced is proportional to the
concentration of oxygen present.
Is This Answer Correct ? | 1 Yes | 2 No |
If a normal magnetic type flow transmitter that can measure flow, temperature and show this parameters on field, is it possible by any means to get this (flow and temperature) parameters info. On dcs? And if yes then with HART, FO communication or any other communication system?
1 Answers Process Control Technologies,
i want use pressure transmitter for flow ,how?
how u meassure room temp?is it possible 2 meassure room temp by rtd or thermocouple?between rtd n thrmocouple which is more regard?3 meassure diff. between rtd n thermocouple?
how to control motor load with rpm or vfd
What is the working principal of Mass flow transmitter?
How to calibration coriolis flow meter?
Name four general (not technical) criteria that would you consider important, when deciding upon a particular control valve?
what is plc? breif explain
one rtd sensor which is connected at middle of distillation column where actual temp. is 100deg but when we tight this sensor at thermowell end it goes down to 90 deg & when remove from the thermowell(but sensor end dipped in well) showing actual reading, what is reason?
What is loop checking ?
10 Answers Kharafi National, Petrofac, Samsung,
what is weighfeeder
how to calibrate load cell