What should be the Sandwitch type Al. bus bar capacity for
2 M.W.Gen. set, having continuous full load current- 3463
Amps,ambient temp.- 50 Deg. C., Required temp. raise-20
deg.C., it will run 24 hrs, 365 days on full load, required
highly reliable.
No Answer is Posted For this Question
Be the First to Post Answer
is the value of inductance depends upon the evalue of thitha in doubly excited machine?
1.what is use of isolation transformer. 2.Differance between KWH,KVAH,KVARH,KVA. 3.Main use of the CT and PT.
what happens if sf6ckt breaker gas pressure is high or low about the actual rating of gas pressure(5kg/cm2)
Difference between divercity and power factor
what is closing resistor in circuit breaker? why it used?
What is reactive power and where it is used.
Why tripping not occur when the transmission lines (11KV & above) breaks? Doesn't we provide earthfault protection for it?
Is it recommended to apply H.pot test for new cables segments after terminations or joints, however, this cable has been tested before at the manufactor by the vendor ? or only we can apply megger tests ?
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
How much difference can there be between HT & LT KWH unit consumption at the same load?
Explain about c.t?
when a airgap of the induction motor gets larger does it draw more current ??? does it power factor gets lower?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)