Answer / laxit

Safety integrity leve has nothing to do with F&G System.
First of all you need to do SIL study for the system.In
case if you landup in SIL-0 or 1 or 2 system you can use
relavant type of SIL system. Inshort it depends upon your
SIF/SIL workshop outcome.

Answer / mike

4

what is consistency transmitter and describe its working?

1 Answers   Emami,

---

what is sequence table in DCS . make a logic in sequence table for tripping of ID fan in Boiler(in YOKOGAWA CS 3000 DCS).

1 Answers   Yokogawa,

---

Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com

0 Answers   IOCL,

---

how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?

0 Answers   Chevron Phillips,

---

calibration of instruments.

11 Answers   ONGC,

---

Why we are using thrust bearing at turbine side?

3 Answers   Edac,

---

can we replace a pressure transmitter of range 0 to 25 Kg/cm2 by a Pressure transmitter of range 0 to 10 Kg/cm2 ?.. Will it affect 4 to 20 mA output signal which we will feed to the PLC.

9 Answers   IOCL,

---

Draw a 3 element level control loop and explain

1 Answers   CCIE,

---

Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?

0 Answers  

---

A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.

0 Answers  

---

Why we use mmwc unit for pressure

3 Answers  

---

Hello Friends do you know this answer of this Question? Which color you would use when there is Somthing not correct or need to change In P&ID? i mean color that use for highlight that need to update in P&ID. Yellow Highlighter ? Red color ? Blue Color ? Appreciate for your answer. Thanks Blue Color

2 Answers  

---