Answer / bala

LOAD CALCULATION THESE THREE POWERS ARE REQUIRED.
Capacitor rating in KVAR-DEPENDS ON THE INDUCTIVE LOAD ,TO
IMPROVE THE LAGGING POWER FACTOR TO LEAD, REACTIVE POWER IS
REQUIRED.
Equipotential wire used in HT transmission for balancing
purpose.

How to calculate capacitor bank size at a load 800kVA.

0 Answers  

---

On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?

0 Answers   Semac,

---

What is maximum power transfer theorem?

0 Answers  

---

How to select the rating of the Transformer?

2 Answers  

---

if the supply voltage increased by N times, the x-section of conductor will be.........

2 Answers   APGenco, Electrical Tech, Ericsson, IES, Thirumalai Chemicals,

---

How Grading Rings & spacers in transmission lines works?working principle?

1 Answers  

---

Sir, I m 3rd year student 4m DCE and want to do internship in siemens or l&t or any other mnc related to electrical engineering. please tell me the procedure 4 same and oblige me

0 Answers  

---

hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused

0 Answers  

---

what is the maximum genarating voltage in india?

32 Answers  

---

my question is that....few days ago i had installed a three phase motor starter for an electric saw.the motor will run and make the hydraulic pressure which will be goes to pressure cylender by up and down lever.two number of limitswitches are also installed on cylinder for safety of motor.now when the arm of cylinder reaches to the upper or lower limit it will cut the motor's line.and motor will be stop.now wana know that what will i do that motor runs continue after the limitswitch cut it down but it shold not be made any pressure.pls answer me in brief.

3 Answers  

---

There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?

0 Answers  

---

how to calculate the distance relay faulty zone?pls explain?

0 Answers  

---