Answer / dinesh dafare

40 w bulb is high resistance approximately 1322 ohms and
100 e bulb is low resistance approximately 529 ohms .
Hence in series circuit voltage divide and current same.
Hence current required to 40 w is less than 100w so 40 w bulb is brighter

Answer / devansh

100 watt as
by the formula p=i^2r
p is directly proportional to r
i.e more power more resistance hence,100 watt will glow brighter

Answer / devansh

cont. my answer all above are wrong as the formula used is
p=v^2\r which is used in parallel as v remain contant while
taking p is inversely proportional to r and it happen in
parallel
so 100 watt

Answer / pavan kumar g

100w bulb will glow,Because this bulb wattage more than other one .

Answer / avinash

100 W bulb will be more brighter because same current will
enter in both of them but since the wattage of 100 W bulb
is more it dissipates more enery in form of heat and light
this is law of conservation of energy phenomenan

Answer / rohitsainirohitji

both bulb will glow equally .Because current entering in
both nbulbes is equal since they are connected in series

why we use star and delta connection?why we donot give the supply directly?

12 Answers   Hitech, Siemens, Tata Steel Limited,

what is meant by displacement & magnitude ?

2 Answers  

If the Power Factor of generator is 0.85...What does this mean and Can the motors connected to this generator operate at PF more than 0.85 ?

1 Answers  

What is C-factor?why it is required to consider in fault short circuit calculations?

2 Answers  

why we step/down voltage in multipul of 11kv?

4 Answers   Siemens,

what principle the cabel TV channels are transmitted? will you be able to check the power at the connector behind your TV with a tester?If yes what is the supply level?

1 Answers  

How Many safety of Air circuit breaker

2 Answers  

onan full form

5 Answers  

what is the difference between arc and spark

2 Answers  

WHAT IS THE USE OF EARTH SWITCHES?

3 Answers   L&T,

What is meaning of DRU in gen.of AVR.

2 Answers  

what should we do when the CT secodary gets open? how do we short circuit it? using tester or screw driver? not dangerous?

6 Answers