if C.R increases then detonation will increase or decrease

Question Posted / pintu9774689249

4 Answers
4230 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

if C.R increases then detonation will increase or decrease..

incresses

with increase in c.r the temp will also increase.
this will lead to localized ignition of air fuel mixture and
hence detonation

Is This Answer Correct ?

3 Yes

0 No

if C.R increases then detonation will increase or decrease..

Answer / rajesh

It make more influence to Petrol engines... Their will be
Pr-ignition occurs...but it is benefits of diesel engine
unto some extend..but it lead to metallurgic problem if c.r.
increases.

Is This Answer Correct ?

1 Yes

0 No

if C.R increases then detonation will increase or decrease..

Answer / dr. muhammed mohsin khan

since compression ration is increasing it will result into more pressure followed by increased temperature thereby resulting into the localised ignition of air fuel mixture thus hence proved the detonation will increased

Is This Answer Correct ?

1 Yes

0 No

if C.R increases then detonation will increase or decrease..

Answer / bittu kumar

is it correct in case of si engine their is no soot formation

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

what are the alignment methods for any two turbine shafts and formulae

2 Answers

What are the protections required to protect turbine?

4 Answers NTPC,

what is procedure of measuring operating length of mechanical seal.(in case of centrifugel pump)

0 Answers ITC Infotech,

Do you need to be an apprentice for mechanical engineering?

0 Answers

What is pneumatic system?

0 Answers

Heavy fuel oil sulfur content and counter measures?

0 Answers

what do u understand by the term "Rotor Long" and "Rotor short"?

3 Answers

an engine operates between temp of 900k and t2 and another engine operates between t2 and 400k. for both engines to do equal work what shuld be the value of t2? a)650 b)600 c)625 d)700 e)750. with explaination.

6 Answers General Motors GM,

whats the Formula to calculate temperature of steam at given pressure

0 Answers

what are "R-condition"and "T-condition" in the designation of Steels ??

0 Answers KLR Industries,

what is more dangerous longitudinal stress or Hoop stress and why?

3 Answers Bhel,

what is difference between 1ton to 1HP

2 Answers

For more Mechanical Engineering Interview Questions Click Here