Answer / iamdon

CT is designed for operation in linear region.In this
region only, current changes acoording to turn ratio.Knee
point on magnetisation curve of core is the point at which
core begins to saturates.Once the core gets saturated, it
losses the transformation propery.It will carry same
secondary current for all primary current.This maloperation
is of no use as far as CT action is concerned.

Knee point sets the upper limits of B so as not to exceed
this limit during operation.Thus it ensures the intended
operation of CT.

Author:arbelectbit@yahoo.com

If a 1.5V,3W torch light bulb is connected in series with a 15HP/11.19KW,230V single phase motor and the combination is connected against a 230V supply and switched on than what will happen keeping all other parameters as it should be A)the bulb will glow normally B)the bulb will not glow C)the bulb will glow with extra brightness D)the bulb will burn out and if a fuse is connected to the above circuit will something happen to the fuse and what about the single phase motor will it be affected? Please explain with derivation

4 Answers  

---

line diagram for mcb , mccb , rccb .

1 Answers  

---

If a three phased motor or not working phased change on poles so how to find which one red yallow & blue

1 Answers  

---

In star and delta connected systems , for driving power and as well as light load which one you will preferred?

2 Answers   Aramco, IBM,

---

it is difficult to interrupt a capacitive current because (a)it has a leading power factor (b)current magnitude is very small (c)the restriking voltage can be high (d)stored energy in the capacitor is high

2 Answers   DGVCL Dakshin Gujarat Vij Company, MGVCL, UGVCL Uttar Gujarat Vij Company Ltd,

---

what is emitter follower configuration? and what are it's features?

1 Answers   IBM, TATA,

---

what is the simple meaning of harmonics?

4 Answers  

---

what is the difference between earthed system and unearthed system.. where do we use unearthed system because in electrical catalogues always cable for earthed and unearthed system is given..pls elaborate

3 Answers  

---

How can the direction of a three phase induction motor be reserved

4 Answers  

---

differance b|w ground, neutral&earth

11 Answers   Bhel, SKH Metals,

---

Why 3 over-current and 1 earth fault relay is used on primary side of transformer? Why 2 over-current and 1 earth fault relay in used on secondary side of transformer?

1 Answers   Adani,

---

IS HI-POT TEST DONE ON A TRANSFORMER - YES OR NO? WHY?

4 Answers  

---