Is the inductance parameter of transmission line affected
by taking the earth into consideration?is the same true for
capacitance?
Justify the answer.
Answer / iamdon
The inductance parameter of transmission line is not
affected by taking the earth into consideration,
Because Inductance is a series parameter.So it has nothing
to do with taking or excluding the earth into consideration.
However the conductance parameter of transmission line is
increased by taking the earth into consideration,because
the capacitance is a shunt parameter.
Author:arbelectbit@yahoo.com
Is This Answer Correct ? | 4 Yes | 0 No |
whats happen if we disconnect the NGR of alternator in running condition?. Generally we observed that transformer netrul is directly grounded but alternator connected with NGR, then ground?
During speed control of dc shunt motor with flux control methode,when armature voltage is constant, How can it possible to increasing the armature current?
friends., why celling fan rotate cockwise direction and wall fan anticickwise direction ?
What are your future plans for the company if permanently employed?
Why do you use an isolator on both sides of the circuit breaker? ( shortly answer)
What is the difference between emf, voltage drop and potential difference?
What are the types of lighning arrestor protection system? how to choose that according to load?
What is the function of NGR for the parallel operation of alternator? whats happen when different rating of alternator are running with parallel?
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
what is phase angle ? and also tells me why my phase-phase voltages are 390 rather then my single phase voltages are 221 and 223 respectivly?
When should I use earth leakage circuit breaker for incomer and when should I use it for each feeder seperately?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?