As per the theory current doesn’t flows in Neutral, but
practically it is
not applicable, explain why?
Answers were Sorted based on User's Feedback
Answer / shariff
If the all the three phase have equal loading them In=0, but in practical , the phase loading will differ, hence the differ current fill flow in neutral.
Is This Answer Correct ? | 6 Yes | 1 No |
a) ? Is it Single Phase system or 3 phase system
b) If it is Single phase system, full current will flow
thro Neutral. Current flows thro Phase, Load and Returns
thro Neutral. ? Clear
c) If it is 3 Phase system ( Star Connected with Neutral)
and if the Connected LOAD IS BALANCED, No Current will flow
thro Neutral. If the LOAD IS UNBALANCED, Unbalance current
will flow thro Neutral
I will stop with this. Otherwise we have to write more
N Manivannan
manivannan20@hotmail.com
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / arvind
because it depends upon the load, what type of load are
connected like linear and non linear load, which is always
be present as an load so this make the voltage fluctution
and cause small amount current to flow to neutral.
Is This Answer Correct ? | 1 Yes | 1 No |
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
0 Answers IHG InterContinental Hotels Group,
what is the use of earthing ?
why we use ac system in india why not dc
1. What are the tests to be carried out for CBCT? 2. can measure the secondary resistances? 3. with respect to secondary maximum how much voltage can be applied for IR test.
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
How earthing of switchgear system to be done.
what is the use of neutral displacement relay
why ELCB can't work if N input of ELCB do not connect to ground?
difference between substation & grid substation?
How transformer winding & oil gets heat.
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
why we use negative feedback in control system.