Answer / prabhas

Usualy in large industries the cable size is calculated,
for 1A of current its 1 sq mm of aluminium cable and 0.5sq
mm of copper cable.

Ex: In case 600A : 300 sqmm or 2R x 150 sqmm cable to be
preferable. in same case iys 150sqmm of copper cable is
enough.

Prabhas

Answer / n r@jesh

For Al. cables 1Amp = 1 sqmm
For cu. cables 2.5Amps = 1 sqmm

i want to know about for what reason we are using star delta starter? how it works? what are the advantages?

4 Answers  

---

can someone explain that how the speed of the protection system affects the fault level calculation?

0 Answers  

---

how does a submersible pump work..?

0 Answers  

---

At the time of 1st charging of transformer, there were huge inrush current, so why at that diffrential relay are not operated? Why?

3 Answers   Adani,

---

in catridge heeter  watts =110, 260 v ,  i checked in multimeeter meeter shows 50 ohms but oms law r=v square /w  260*260=67600, and 67600/110=614.5 ohms  how to caluclate exact ohms in heetre s 

2 Answers  

---

---

State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp

0 Answers  

---

why the transmission side of the generating transformer is always star??

5 Answers  

---

time constant of RC series circuit?

2 Answers   DVC,

---

wt wil happen if a 120kv line is grounded

4 Answers  

---

The error in a single phase energy meter where pressure coil lags behind applied voltage by 88 degrees and pf is 1) upf 2).5lag

1 Answers   GATE,

---

What is rotor angle stability?

2 Answers  

---

what is per unit calculation?looking for simple and strong explanation thk u

0 Answers  

---