what is the formula to calculate the fuel consumption of a
diesel generator at different diferent load.
Answers were Sorted based on User's Feedback
Answer / laxmikanth
yes sir without formula how can we calculate 0.20 or 0.21
Is This Answer Correct ? | 7 Yes | 2 No |
Answer / jahedul amin
Dear,
Actually there is no formula. It depends on Manufacturer,
GenSet load etc.
But usually people use 0.20 or 0.21 Litre/KW-Hr.
Jahedul Amin
Is This Answer Correct ? | 11 Yes | 7 No |
Answer / sanjeev goyal
In fact fuel consumption varies with actual load but as a Rule of Thumb, based on actual figures it is safe to take 0.2l/hr-kw as fuel consumption of diesel generator
Is This Answer Correct ? | 5 Yes | 1 No |
If not into production, how far did you follow the design and why did not you see it into production?
0 Answers Bharti, Havells, Intel,
ohm's law is applicable to DC/AC/Both??
How to power regulated by AVR in Alternator?
Earth Is a very good conductor or very good insulator.? If a good conductor then why current donot flow through small piece f earth and if a good insulator then why we use it as return path in lines.???
What is different bewteen low or high impedance busbar protection scheme
my question is that....few days ago i had installed a three phase motor starter for an electric saw.the motor will run and make the hydraulic pressure which will be goes to pressure cylender by up and down lever.two number of limitswitches are also installed on cylinder for safety of motor.now when the arm of cylinder reaches to the upper or lower limit it will cut the motor's line.and motor will be stop.now wana know that what will i do that motor runs continue after the limitswitch cut it down but it shold not be made any pressure.pls answer me in brief.
where we use 1 phase & 3 phase supply ?what is major advantage using 3 phase over than single phase ?
How to size Air Circuit breaker (ACB)? What is the most important factors?
advantage of using 110v than 230v
dielectric strength of vacuum is greater than SF6 but for 132Kv uses sf6 breaker & for 33kV uses vaccum breaker why such a contradiction?
2 Answers MSETCL Maharashtra State Electricity Transmission Co Ltd,
What is power factor? Whether it should be high or low ? why?
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables