what will happen when a electric bulb is connected between
two phases.it will glow or not
Answers were Sorted based on User's Feedback
Answer / sampath
yes , The will glow .i really don't know the theory behind it but having practically seen it ,i am sure . u guys must try.
Is This Answer Correct ? | 2 Yes | 3 No |
Answer / nagendra
if two phase voltages are equal that means 230v.then what will happen
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / satadal
Actually this is dependent on phase voltage and lamp rating voltage. In India the supply voltage is 440 V,50 Hz. for 3 phase.
and normally we will get 220 V at single phase with neutral
& 420V with Phase to Phase.
if our Bulb is rated for 240 V and we connected between two phase, the bulb get fuse due high volage.
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / asad durez
If we connect a bulb between two opposite phases for
example (red,yellow)(red,blue)etc.then minimum conect 200
watt lamp because of potential is to high with comapare to
single phase.
+92-334-9107748
Is This Answer Correct ? | 1 Yes | 6 No |
Answer / guest
2 phase kuch nahi hota? 3 phase me 2 line ke bich connect
krn pe bulb on ho ga ta hai .
Is This Answer Correct ? | 6 Yes | 12 No |
Answer / vignesh.d
NO, i hope. bcoz the circuit has to be closed to glow.
Is This Answer Correct ? | 11 Yes | 26 No |
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
1. Why a DC motor starter is called 3 point starter
21 Answers ABB, CG, College School Exams Tests, Crompton Greaves, Infosys, Siva,
The maximum demand of consumer is 2 kW and his daily energy consumption is 20 units. Its Load Factor is (1) 10.15% (2) 41.6 % (3) 50 % (4) 60%
what is the diffrence between earth and neutral.
What is rotary phase converter?
iii) A shunt motor runs at 70 rad/sec from a 460V supply and takes in an armature current of 100A. Resistors of 2.52 ohms and 1.64 ohms are connected in series with the armature and in parallel with the armature respectively. The field excitation remains direct from the 460V supply but the generated torque is halved. Determine the new running speed. Neglect brush voltage drop. The armature resistance is 0.4 ohms. [15]
in CNC reference how to take? what kind of input give to the servo amplifier?
what is diode? and what it is used for ?
how to determine motor size for a fan application?
what is PID control in VFD drives?
What is SF6 Circuit Breaker?
If R and Y terminals are short circuited,then power will cut. we all know that power cannot be stored.what will happen to already generated power at power station?