Answer / j.gopalakrishnan

nothing is happen

Answer / balaji

1.Normally for villages we will use 415 volt supply.if we
use two different transformers we cant interchange neutral
because in transformer secondary side neutral will be
earthed.if you interchange means circuit will not closed.

Answer / b.k.rai

if single phase supply 230vac,then nothing happens

Answer / karthikeyan

nothing happen

Answer / amarnath

Very simple the circuit trips...

Answer / vipul bhavsar

In distribution if neutral interchanged but both is healthy
nothing happened,in case one neutral got loosed or opened
than unbalanced voltage will be induced in each phase and
it may be in KV for Milli sec. also so will fused electronic
component also, you also hear that due to GEB high voltage
television got fused this happen due to neutral shifting.

Answer / rajesh tewari

plz explain the question....that whose interchane 1
phase..2phase...3phase and neutarl

What is phase angle? and what is importance to measure it?

2 Answers  

1 Amp = kva ? 1 Amp =KW ?

3 Answers   Marriott,

what is the difference between 3 phase 3wire &3phase 4 wire meter?what is the advantage of 3p3w over 3p4w?

1 Answers   L&T, MahaDiscom,

if 11 lead acid batteries each 200 amph are connected in series so that combinly they can produce 110 volts dc. question is how much backup it can provide ? 2) how can we calculate that how much amprere and voltage is required to charge them . thanks in advance !

1 Answers  

How much voltage we need to apply in 33kv cable during hipot test of cable

0 Answers  

How can you measure the signal from the PT100 sensor?

1 Answers  

what is the function and use of cable differential protection relay?

0 Answers  

when transformer in load condition neutral earth testing wheater we can do it or not

1 Answers  

in short circuit. test of a transformer 5 to 10% ofvrated voltage is used why??? if we use rated voltafe then what will be?

1 Answers  

What is thresh hold value of current?

0 Answers  

what is the difference between earth, neutral and ground?

1 Answers   Farnek, Shyam Indus Power, Spiro Solutions,

How to design power source say 5KW i/p :415v 3 ph, o/p 5KW constant, variable currnt and variable volatge 10-230v,

2 Answers