How can we get a Neutral from a three phase suply? If we meet all three phases

How can we get a Neutral from a three phase suply? If we
meet all three phases at a point to take neutral then why
dont thay get sparked?

Question Posted / uzair

1 Answers
4732 Views
I also Faced
E-Mail Answers

How can we get a Neutral from a three phase suply? If we meet all three phases at a point to take ..

Answer / shan80

u know that there is two type three phase supply star and
delta. delta connection has three wires. these wire are
three phases only there is no nutral and in star there is
fout wire three for phase and one for neutral. make sure
what is ur connenction type.
and ur idea to connect these phases each other for making
nutral point is absolutly wrong it is a dead short circuit
and become harmful.
whereas the point of neutral in star is junction of only
one end of three different coils (coil of transformer,
motor or genrator etc.) and other ends representing three
phases.
i think u should clear with that.
thanks.

Is This Answer Correct ?

17 Yes

3 No

Post New Answer

More Electrical Engineering Interview Questions

What is relation bet kvar & microfarad

2 Answers

What is the difference between AVR and Servo Stabliser

3 Answers Wipro,

X/R ratio in 11kv transmission line is?

1 Answers RRB,

please explain how to do 'pole drop test' on generator?

0 Answers

If the generator will not synchronize, what will you do?

3 Answers

what happen if we supply 220v dc suppy to the bulb or tube

2 Answers

why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor

0 Answers Indcoil Transformers, Power Grid,

Hello every one I am currently working in IT side but i have an offer to work under 'A' license holder and he says i can get c license what is the use of c license and what shall i do after getting it basically i am an electrical graduate please help me shall i leave this it job and work in electrical maintenance will i have a good future i am confused Thank You in Advance

1 Answers

if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side

0 Answers

A resistance of 50 kΩ has a conductance of:(a) 20S(b) 0.02S(c) 0.02 mS(d) 20 kS

1 Answers

Whet is IGBT.How it teste

2 Answers

what is the use of buchzloys relay?

2 Answers

For more Electrical Engineering Interview Questions Click Here